1200 III EP Update Instructions - Method One

Following this method will update the 1200 III EP driver and allow it to be used with the Direct Scan function.

Step One - Delete the Previous Drivers

It is recommended to delete the previous TWAIN drivers before installing an upgrade. Click here for instructions on removing TWAIN drivers.

Step Two - Load Original Driver from the CD

In order to utilize the Direct Scan feature, the driver from the original installation CD must be installed first. Follow these steps:

1. Insert the 1200 III EP Scanner Installation CD. If your system has the Autorun feature enabled, the disk will launch and display the Installer screen within a few seconds. If your system does not have Autorun, or if you are using Windows 3.1x, you will need to access the disk through the Run command.

Without Autorun

1. Click on Start and select Run.

2. Type D:\run.exe where "D:\" equals the letter of your CD-ROM drive.

3. The installation should begin.

With Windows 3.1x

1. Click on File and select Run.

2. Type D:\run.exe where "D:\" equals the letter of your CD-ROM drive.

3. The installation should begin.

2. The installer will come to a screen with two options: Typical or Custom installation. Click the radio button in front of the Custom option and click Next.

3. The installer will display a group of set-up options. Uncheck all of the boxes except for the one called "Mustek 1200 III EP Scanner Driver" and click Next.

4. When the installation directory is displayed, click Next to accept the default.

5. Click OK when prompted to accept the Acrobat Reader license agreement.

6. When prompted to choose the Tutorial or Finish, click Finish.

Step Three - Install the Updated Driver

Click on the file name of the updated driver and it will install.